Cleaning The Floor Nozzle; Cleaning The Brush Roller - Bosch BSS8 Série Mode D'emploi

Cleaning the floor nozzle
31
a
2
b
c
1
76

Cleaning the brush roller

Before carrying out any mainte-
nance, switch off the vacuum clea-
ner and disconnect it from the char-
ging cable.
31
Fig.
a) Turn the rotary brush anti-clock-
wise to unlock it and pull it out to
the side of the floor nozzle.
b) Use scissors to cut through th-
reads and hairs wound round the
rollers along the cutting groove.
c) Slide the rotary brush into the
floor nozzle and turn it clockwise
to lock it in place.
‡ The brush roller is also self-
cleaning. Use scissors to cut
through the hairs and fibres
lengthways on two opposite si-
des. Then operate the brush roller
for 30 seconds to vacuum these
up automatically.
Caution!
The floor tool must only be put
into operation with the brush rol-
ler fitted.