Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
aSSeMBLY INSTrUCTIoNS
TooLS reQUIred For aSSeMBLY
(1) Hammer
(1) Pliers
(2) 7/16" Wrenches
(2) 1/2" Wrenches
Lay out and identify parts and hardware using the
illustrations on pages 2 and 3.
STep 1:
(See FIGUre 1)
•
Insert a plug (AA) into the end of the hitch tube (9).
•
Attach the hitch bracket (8) to the hitch tube using two
5/16" x 1-1/4" hex bolts (G) and 5/16" nylock nuts (I).
Tighten.
•
Install the hitch pin (A) in the hitch bracket and hitch
tube and secure it with the hairpin cotter (T).
A
T
STep 2:
(See FIGUre 2)
•
Attach the hitch support tubes (3), and (4) to the hitch
tube using one 1/4" x 2" hex bolt (C) and 1/4" nylock
nut (J). do not tighten completely.
3
J
AA
G
8
9
I
FIGUre 1
4
C
FIGUre 2
STep 3:
(See FIGUre 3)
•
Insert plugs (AA) into the ends of the hopper support
tubes (5) and (6).
•
Attach hopper support tube (5) and hopper support
tube (6) to the hitch support tubes as shown, using
two 1/4" x 1-1/2" hex bolts (E) and 1/4" nylock nuts (J).
do not tighten completely.
AA
STep 4:
(See FIGUre 4)
•
Insert the bushing (Y) into the cross brace (7).
•
Attach the cross brace to the hopper support tubes
using two 1/4" x 2-1/2" hex bolts (B) and 1/4" nylock
nuts (J). do not tighten completely.
B
4
5
AA
J
E
J
J
B
6
J
E
FIGUre 3
Y
7
FIGUre 4
Publicité
Table des Matières
