Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STep 5:
(See FIGUre 5)
•
Install the gearbox by inserting the end of the verticle
shaft into the cross brace bushing and inserting the
axle into the ends of the hopper support tubes. Be
sure the hole in the axle is located on the side shown
in figure 5.
hole on this end
STep 6:
(See FIGUre 6)
•
Slide the flat sided bearings (W) onto the axle and
insert them into the ends of the hopper support tubes.
•
Slide the spreader impeller (12) onto the spreader
shaft and secure it with a 1/8" x 1-1/2" cotter pin (Q).
W
STep 7:
•
Place the hopper on the hopper support tubes,
inserting the spreader shaft up through the square
hole in the bottom of the hopper.
•
Slide the hopper bushing (X) onto the spreader shaft
and insert it into the bottom of the hopper.
•
Slide the spacer (K) onto the spreader shaft.
•
Install the agitator hairpin (S) in the spreader shaft.
FIGUre 5
STep 8:
•
Attach the hopper to the hopper support tubes using
four 1/4" x 1-3/4" hex bolts (D), 1/4" washers (M),
nylon washers (N) and 1/4" nylock nuts (J). Make only
finger tight.
•
Insert the 1/4" x 1" hex bolt (F) into the hole in the
bottom of the hopper, pressing the head of the bolt
into the hex shaped recess of the hole. Install a 1/4"
nylock nut (J) onto the bolt and tighten.
12
Q
W
FIGUre 6
5
(See FIGUre 7)
S
K
X
(See FIGUre 8)
D
M
N
J
J
FIGUre 7
F
FIGUre 8
Publicité
Table des Matières
