Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STep 9:
(See FIGUre 9)
•
Install the grip (BB) onto the flow control arm.
•
Assemble the adjustable stop (V) to the flow control
bracket using the 1/4" x 3/4" carriage bolt (H), nylon
washer (N) and wing nut (U).
U
N
V
H
STep 10:
(See FIGUre 10)
•
Attach the flow control bracket to the hitch tube using
two 1/4" x 1-3/4" hex bolts (D), four 1/4" washers (M)
and two 1/4" nylock nuts (J). do not tighten
completely.
J
M
M
BB
FIGUre 9
D
FIGUre 10
STep 11:
(See FIGUre 11)
•
Install the end of the flow control rod (10) with no hole
into the elongated hole in the flow plate on the bottom
of the hopper. Lock the rod in the flow plate by rotating
the rod.
STep 12:
(See FIGUre 12)
•
Swing the flow control rod around and insert the end
of the rod into the flow control arm. Secure it with a
1/4" washer (M) and a 3/32" x 3/4" cotter pin (P).
P
6
FIGUre 11
M
FIGUre 12
Publicité
Table des Matières
