Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STep 13:
(See FIGUre 13)
•
Fasten the hopper braces (11) to the hopper support
tubes using the nylock nuts (J) that were assembled
earlier. do not tighten completely.
•
Fasten the loose ends of the hopper braces to the
hitch tube using a 1/4" x 2" hex bolt (C) and a 1/4"
nylock nut (J). do not tighten completely.
J
11
J
STep 14:
Tighten all bolts and nuts except for those shown in
•
step 10 that fasten the control bracket to the hitch tube.
STep 15:
(See FIGUre 14)
•
Slide a 5/8" washer (O), a spacer (L), a 5/8" washer
(O) and a wheel onto the end of the axle with no hole.
•
Carefully hammer a hub cap (Z) onto the axle.
Z
O
L
J
11
C
FIGUre 13
O
FIGUre 14
STep 16:
(See FIGUre 15)
•
Slide a 5/8" washer (O), a spacer (L), a 5/8" washer
(O) and a wheel onto the end of the axle with a hole.
•
Attach the wheel to the axle with a 3/16" x 2" cotter
pin (R).
•
Carefully hammer a hub cap (Z) onto the axle.
STep 17:
(See FIGUre 16)
•
Set the adjustable stop at "5" and move the control
hande back against it.
•
Slide the control bracket along the hitch tube until the
flow plate in the bottom of the hopper is open half way.
•
Tighten the bolts and nuts fastening the control
bracket. Do not deform the control bracket.
•
Make sure the flow plate will open and close all the
way. Readjust if necessary.
7
R
O
L
O
SETTING "5"
Z
FIGUre 15
FIGUre 16
Publicité
Table des Matières
