Table Des Matières; Assembly; Tools Required For Assembly - Agri-Fab 45-0326 Notice D'utilisation

For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
CONTENTS
SAFETY .......................................................................... 4
ASSEMBLY ..................................................................... 5
OPERATION ................................................................. 11
MAINTENANCE ............................................................ 11
STORAGE ..................................................................... 11
SERVICE AND ADJUSTMENTS .................................. 12
TROUBLESHOOTING .................................................. 12
REPAIR PARTS ............................................................ 22

ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

(1) Knife or Scissors
(2) 1/2" Open End or Box End Wrenches
All loose parts are shown on page 2. Fasteners in the
parts bag are shown full size on page 3.
Remove the hardware pack and all loose parts from the
carton and verify that all the parts and fasteners shown
on pages 2 and 3 are included.
ASSEMBLY OF SWEEPER
Note: Right hand (R.H.) and left hand (L.H.) are deter-
mined from the operator's position while seated on the
tractor.
1. (Figure 1) Assemble the angle bracket to the sweeper
housing using a 5/16" x 3/4" hex bolt (F) and a 5/16"
hex lock nut (G). Make sure the bracket is turned as
shown and aligned straight with the housing and then
tighten.
5/16" HEX
LOCKNUT (G)
ANGLE
BRACKET
5/16" x 3/4"
HEX BOLT (F)
ENGLISH
2. Cut off the plastic tie that holds the height adjustment
3. (Figure 2) Assemble the R.H. hitch tube to the
4. (Figure 3) Fasten the hitch tubes together using
1
5
www.mymowerparts.com
tube in place.
sweeper housing using two 5/16" x 1-3/4" carriage
bolts (D), 5/16" lock washers (K) and 5/16" hex nuts
(H). Do not tighten yet. Repeat for the L.H. hitch
tube.
5/16" LOCK
WASHER (K)
5/16" x 1-3/4"
CARRIAGE BOLT (D)
two 5/16" x 3" hex bolts (A), 5/16" small flat washers
(I), 5/16" lock washers (K) and 5/16" hex lock nuts
(G). Do not tighten yet.
5/16" x 3"
HEX BOLT (A)
2
5/16" HEX NUT (H)
3
5/16" HEX
LOCK NUT (G)
5/16" LOCK
WASHER (K)
5/16" SMALL FLAT
WASHER (I)