Fortress Building Products V Série Instructions D'installation page 26

Step 2: Bottom Bracket Installation Continued
1. Use Spring Punch to mark holes. As shown in Fig. 1. below.
2. Drill out bracket hole with a 3/16" [5mm] drill bit.
As shown in Fig. 2 below.
3. Use T-25 screws to attach UB-05 Adapter Base to the post.
Begin with top hole then bottom. As shown in Fig. 3 below.
4. Keep bracket base centered as you install second screw.
5. Insert barrel & screw to re-assemble UB-05 Adapter.
6. Tighten barrel & screw. As shown in Fig. 4 below.
7. Use Phillips Head Thread-Cutting Screws to attach UB-05
Cup to UB-05 Adapter. As shown in Fig. 5 below.
Fig. 1
Fig. 3
Fig. 5
26
Fig. 4
V-SERIES: VERTICAL CABLE INSTALLATION
Fig. 2