Operation - Beurer ELLE HSE 30 Mode D'emploi

6

Operation

Important
• Straighten the mains cable [8] if it becomes
twisted.
• Do not pull, twist or kink the mains cable
[8]; do not pull or lay it across/on sharp,
pointy objects or hot surfaces.
• Do not jam the mains cable [8] e.g. in a
drawer or door.
Warning
• Stand on a dry, electrically non-conductive
surface.
• Ensure that your hands are dry!
• Your hair must be dry!
• Depending on the temperature setting and
duration of use, the unit can become very
hot. If the unit is hot, touch it only by its
handle – burn and fire hazard!!
• Do not touch the heating plates [1].
• Switch the unit off immediately if it is
defective or malfunctioning.
• Unlock the straightener's lock [9] by turning
it anti-clockwise.
14
• Press the on/off switch for two seconds [5].
- The unit is shipped with a default
temperature setting for normal hair
(160 °C).
- The warm-up phase is displayed by a
running light in the temperature
display [2].
- When the default temperature or the
selected temperature is reached, this is
displayed by a continuously lit LED in the
temperature display [2].
- After about 30 seconds, the straightener
is ready for use.
Adjusting the temperature
• You can increase or decrease the
temperature in 20 °C increments using the
+/– buttons [3, 4].
We recommend the following temperature
settings:
• 120 °C to 140 °C:
- Fine, fragile, coloured or bleached hair
• 160 °C to 180 °C:
- Normal hair
• 200 °C to 220 °C:
- Strong and resistant hair
Note
• The higher the selected temperature, the
more quickly you get the desired result.
• If you work with the maximum temperature,
do not work on the same strands more than
once.