Operation; Changing Attachments - Beurer ELLE HTE 50 Mode D'emploi

6

Operation

Important
• Straighten the mains cable [9] if it
becomes twisted.
• Do not pull, twist or kink the mains
cable [9]; do not pull or lay it across/on
sharp, pointy objects or hot surfaces.
• Do not clamp the mains cable [9], for
example in drawers, doors or between the
heating plates [1, 2].
Warning
• Stand on a dry, electrically non-conductive
surface.
• Ensure that your hands are dry!
• Your hair must be dry!
• Depending on the temperature setting and
duration of use, the unit can become very
hot. If the unit is hot, touch it only by its
handle [6] – burn and fire hazard!
• Do not touch the heating plates [1, 2]!
• Do not touch the attachments as long as
they are still hot!
• Do not clamp any objects between the
heating plates [1, 2] and the barrel and the
curling tong.
• Switch the unit off immediately if it is
defective or malfunctioning.

Changing attachments

Warning
• When the attachment is in place on the
unit, always let it cool down before
removing it – burn hazard!
• Select the right attachment [12, A, B, C] for
the desired hairstyle.
• Turn the lock ring [10] clockwise until it
stops. The attachment is unlocked.
• Remove the attachment from the handle [6].
• Align the selected attachment as shown in
the figure.
• Push the selected attachment carefully into the
handle [6], without jamming the two metal pins.
• Turn the lock ring [10] anti-clockwise until it
stops. The attachment is locked.
• Check whether the attachment is firmly
connected with the handle.
• Lay the multi-function styler or place it with
the stand unfolded [13] onto a stable,
horizontal and non-combustible surface or
hold the multi-function styler in your hand to
let it cool.
19