EINHELL SPU 300 Instructions De Service page 3

Anleitung SPU 300
Area of use
The SPU 300 indoor fountain pump is desi-
gned for indoor use only, e.g. in planters, indo-
or fountains, etc.
Technical data
Power supply
Output
Delivery rate max.
Delivery height max.
H (m)
0,60
0,25
0 50 100
Pump design
The centrifugal pump stator is hermetically
sealed in casting resin inside a plastic
housing. It is equipped with a 3 metre long
non-removable power cable plus earthing -pin
plug. During operation the permanent magnet
rotor runs in the water and requires no lubrica-
tion.
31.10.2001 10:17 Uhr
230V ~ 50Hz
6 W
300 l/h
0.6 m
Q (L/h)
150 200 300
Seite 3
Special points to note
G To avoid damage to the bearings, never
allow the pump to run dry.
G
Only ever operate the pump from a proper
230V ~ 50Hz AC socket-outlet with
earthing contact and earth-leakage
circuit-breaker (30mA or 10mA).
G It is prohibited to use the pump outdoors,
e.g. in garden fountains or ponds.
G If the rate or height of delivery drops, clean
the intake housing (01) as follows:
G Open the intake housing (01) by swivelling
downward.
G
Clean the intake housing.
G
When finished, re-assemble the intake
housing.
Particularly if the pump is used with hard
water (high calcium content), you should clean
all its rotating parts at regular intervals. To do
so, remove the intake housing, and take out
the rotor. Clean each single part and re-
assemble in reverse order.
Ordering replacement parts
If you ever need to order replacement parts,
please quote the following data:
1. Machine type
2. Article No. of the machine
3. Ident. No. of the machine
4. Replacement part number of the item
required
GB
3