Noises; Ventilation Requirements - JUNO JCT12210S5 Notice D'utilisation

26
5. Remove the lower door.
6. Loosen and remove the lower pin.
7. Tighten the lower pin on the opposite
side.
8. Install the lower door.
9. Tighten the middle hinge.
10. Install the spacer.
11. Install the upper door.
12. Tighten the upper pin.

NOISES

There are some sounds during normal running (compressor, refrigerant circulation).
Do a final check to make sure
that:
• All screws are tightened.
• The magnetic seal adheres to
the cabinet.
• The door opens and closes
correctly.
If the ambient temperature is
cold (i.e. in Winter), the gasket
may not fit perfectly to the
cabinet. In that case, wait for the
natural fitting of the gasket.
In case you do not want to carry
out the above mentioned
operations, contact the nearest
Authorised Service Centre. The
Authorised Service specialist will
carry out the reversibility of the
doors at your cost.

Ventilation requirements

The airflow behind the appliance must be
sufficient.
min.
5 cm
200 cm
2
min.
2
200 cm