Husqvarna 120 Mark II Manuel D'utilisation page 17

11.Hold the rear handle with your right
hand and the front handle with your left
hand.
12.Immediately pull the front hand guard
rearward in the direction of the front
handle to disengage the chain brake.
Note:
The chain will move.
13.Run 20-30 seconds at elevated idle
speed.
14.Pull the throttle trigger slowly but fully for
8-10 seconds, then release.
15.Run 10 seconds at normal idle speed.
16.Pull the throttle trigger slowly but fully for
5 seconds to check acceleration, then
release.
17.Use the product.
654 - 006 - 10.02.2020
To start a warm engine
1. Move the front hand guard forward to
engage the chain brake.
2. Pull the choke control out fully.
3. Push the air purge bulb 6 times.
4. Push the choke control in fully.
5. Hold the body of the product on the
ground with your left hand.
6. Put your right foot through the rear
handle.
7. Pull the starter rope handle slowly with
your right hand until you feel some
resistance.
8. Pull the starter rope handle with force.
CAUTION:
starter rope until it stops. Do
not let go of the starter rope
when it is fully extended.
Release the starter rope
slowly. If you do not obey
these instructions, it can
cause damage to the engine.
Note:
Do not pull the throttle trigger
when you start the engine.
9. Pull the starter rope handle until the
engine starts.
10.Hold the rear handle with your right
hand and the front handle with your left
hand.
11.Immediately pull the front hand guard
rearward in the direction of the front
handle to disengage the chain brake.
Note:
12.Wait 10-15 seconds.
13.Pull the throttle trigger lightly to set
normal idle.
14.Use the product.
To start the engine when the fuel is too hot
If the product does not start, the fuel can be
too hot.
Do not pull the
The chain will move.
17