Transportation; Storage - Husqvarna 120 Mark II Manuel D'utilisation

4. Tighten the guide bar nuts using the
combination wrench and lift the tip of the
guide bar at the same time.
5. Make sure that you can pull the saw
chain round freely by hand and that it
does not sag.
• Put the transportation guard on the
cutting attachment during transportation
to prevent injuries.
• Always put the product away safely
when not in operation. Leakages and
fumes from the product can touch
sparks, naked flames from electrical
equipment, electrical mowers, relays/
switches, boilers and more.
• Always save fuel in an approved
container.
26
To lubricate the cutting equipment
To do a check of the saw chain lubrication
Do a check of the chain saw lubrication
each time you refuel.
1. Start the product and let it run at 3/4
speed. Point the nose of the guide bar
at a light color surface almost 20 cm (8
in) away.
2. After 1 minute of running, a line of oil
shows on the light surface.
3. If you cannot see the line of oil after 1
minute, clean the oil channel in the
guide bar. Clean the groove in the edge
of the guide bar. Make sure the guide
bar nose sprocket turns freely and that
there are no blockages in the lubrication
hole. Clean and lubricate the tip
sprocket.
4. Start the product and let it run at 3/4
speed. Point the nose of the bar at a
light color surface almost 20 cm (8 in)
away.
5. After 1 minute of running, a line of oil
shows on the light surface.
6. If you cannot see the line of oil after 1
minute, speak to your approved dealer.

Transportation

• Make sure that the product can not
move during transportation.

Storage

• Empty the fuel tank and the chain oil
tank when the product is in storage for
longer periods of time. Discard used
fluids correctly.
• Put the transportation guard on the
cutting attachment during storage to
prevent injuries.
654 - 006 - 10.02.2020