Operation - Husqvarna 120 Mark II Manuel D'utilisation

1. Align the notches on the bar tool so that
they fit over the brake rotating link.
WARNING:
understand the safety chapter
before you operate the product.
To use fuel
CAUTION:
two-cycle engine. Use a mixture
of gasoline and two-cycle engine
oil. Make sure to use the correct
quantity of oil in the mixture.
Incorrect ratio of gasoline and oil
can cause damage to the engine.
Fuel mixture ratio
The fuel mixture ratio for the gasoline and
two-cycle engine oil is 50:1 (2%)
Gasoline
1 U.S. Gal.
14

Operation

Read and
This product has a
Two-cycle engine
oil
77 ml (2.6 oz)
2. To reset the brake, rotate the link
clockwise until it stops. The front link will
be in its downward rotated position
when the chain brake is unlocked.
Gasoline
1 UK Gal.
5 l
To make the fuel mixture
1. Determine the correct quantity of
gasoline and engine oil (mixture ratio
50:1). Do not make more than 30 days
quantity of fuel mixture. See
on page 14 .
2. Add half of the gasoline quantity to a
clean fuel container with an antispill
valve.
CAUTION:
gasoline with more than 10%
ethanol concentration (E10).
This can cause damage to the
product.
Two-cycle engine
oil
95 ml (3.2 oz)
100 ml (3.4 oz)
To use fuel
Do not use
654 - 006 - 10.02.2020