Installing The Relifix V 525Y - HellermannTyton Relifix Série Notice De Montage

Installation

5 .10 Installing the Relifix V 525Y

Proceed as follows:
1 Strip the cables as shown in the figure and align the
cores.
60 mm
Stripping the cables.
2 Align the cores before connecting.
Aligning the cores.
3 Connect the cores with the connector block.
f Observe the tightening torque of 15 Nm.
15 Nm
Connecting the cores.
20
30 mm 60 mm
Installation Instructions • Relifix • 11-2016
4 Open the shell and cut-in all four brush seals according
the diameter of the cables.
Opening and cutting the shell.
5 Position the connector block between the higher ribbed
markings in the shell.
Inserting the cable connection.
6 Spread the cables.
Spreading the cables.