Installing The Relifix V 506Y - HellermannTyton Relifix Série Notice De Montage

5 .8 Installing the Relifix V 506Y

Proceed as follows:
1 Strip the cables as shown in the figure and align the
cores.
55 mm 20 mm
Stripping the cables.
2 Align the cores before connecting.
Aligning the cores.
3 Connect the cores with the connector block.
f Observe the tightening torque of 10 Nm.
10 Nm
Connecting the cores.
55 mm
4 Open the shell and cut-in all four brush seals according
the diameter of the cables.
Opening and cutting the shell.
5 Position the connector block between the higher ribbed
markings in the shell.
Inserting the connector block.
6 Spread the cables.
Spreading the cables.
Installation Instructions • Relifix • 11-2016
Installation
17