HellermannTyton Relifix Série Notice De Montage page 10

Installation
4 Open the shell.
Opening the shell.
5 Cut-in all four brush seals according the diameter of the
cables.
Cutting the brush seals.
6 Position the connector block between the higher ribbed
markings in the shell.
f Use the partition plate for cables with three or four
cores.
Inserting the connector block.
10
Installation Instructions • Relifix • 11-2016
7 Close the shell until the locking mechanism engages.
Closing the shell.
A small amount of gel must emerge around the cable sheath
while closing the shell to be sure that the joint is perfect
protected against dirt and moisture.
8 Secure the shell with cable ties against accidental
opening.
Securing the shell with cable ties.
; The product has been successfully installed.