HellermannTyton Relifix Série Notice De Montage page 15

7 Close the shell until the locking mechanism engages.
Closing the shell.
A small amount of gel must emerge around the cable sheath
while closing the shell to be sure that the joint is perfect
protected against dirt and moisture.
8 Secure the shell with cable ties against accidental
opening.
Securing the shell with cable ties.
; The product has been successfully installed.
5 .7 Installing the Relifix V 150
Proceed as follows:
1 Strip the cables as shown in the figure and align the
cores.
30 mm
Stripping the cables.
2 Insert the cores in the connector block.
Inserting the cores.
3 Connect the cores with the connector block.
f Observe the tightening torque of 15 Nm.
Connecting the cores.
4 Open the shell.
Opening the shell.
Installation Instructions • Relifix • 11-2016
Installation
15 Nm
15