HellermannTyton Relifix Série Notice De Montage page 11

5 .4 Installing the Relifix V 416
Proceed as follows:
1 Strip the cables as shown in the figure and align the
cores.
f A: Straight through connection
f B: Branch connection
10 mm 40 mm
45 mm 10 mm
Stripping the cables.
2 Align the cores before connecting.
Aligning the cores.
3 Connect the cores with the matching press connectors
and right tool.
Connecting the cores.
45 mm 15 mm
4 Open the shell.
Opening the shell.
5 Cut-in all four brush seals according the diameter of the
cables.
Cutting the brush seals.
6 Position the connector block between the higher ribbed
markings in the shell.
f Use the partition plate for cables with three or four
cores.
Inserting the connector block.
Installation Instructions • Relifix • 11-2016
Installation
11