Installation; Installing The Reliseal V 56 - HellermannTyton Reliseal Mode D'emploi

Installation

5 Installation
DANGER
Danger of lethal electric shock!
There is a risk of lethal injury when touching live cables.
f Disconnect the cable from the power supply before
installing the product.
f Only connect the product to a properly installed and
standardised cable.
f Check the voltage-level and current requirements.
The following tools are required for the installation of
the product:
• Cable knive or stripping plier
• Crimping plier
If transport damage has been found or if the scope of
delivery was incomplete, please contact Customer Service at
HellermannTyton.
6
Installation instructions • Reliseal • 07-2016

5 .1 Installing the Reliseal V 56

Proceed as follows:
1 Strip the cable as shown in the figure and align the
cores.
15 mm 50 mm
Stripping the cable.
2 Depending on the cable diameter, insert or remove the
adapter seals in the cable joint.
Inserting the adapter seals.
f Select the adapter seals for the corresponding cable
diameter.
Ø12 - 15 mm
Ø16 - 18 mm
Selecting the adapter seals.
12 - 18 mm
3 x 2,5 - 5 x 6 mm²