SCHOTT Instruments AVS 470 Mode D'emploi page 64

59
error report
meas.
time-out !
remove cause
press Enter
error report
safety sensor
caused!
remove cause
press Enter
Chapter 5 Working with the AVS 470 Viscosity Measuring Unit
Fig. 35 Error message: measurement time-out
The cause of the time-out has to be removed. In
most cases the measurement has to be restarted,
since this error message is almost always caused
by a fatal error, such as viscometer empty,
connected incorrectly or not at all etc.
Please refer to: Chapter 2.4, Trouble Shooting
Press the "Enter" key, and you will be taken back to
Fig. 4
Fig. 36 Error message: safety sensor
In this case the safety bottle has to be discharged
and cleaned, the cause of the overfilling has to be
dicovered and has to be removed.
Press the "Enter" key, and you will be taken back to
Fig. 4