SCHOTT Instruments AVS 470 Mode D'emploi page 63

58
system parameter
memory print out
protocol
documentation:
yes
system parameter
date :
time :
system parameter
date & time
save parameters
yes
system parameter
delete method?
yes
system report
method deleted
press Enter
system report
is the capillary
empty?
press Enter
Chapter 5 Working with the AVS 470 Viscosity Measuring Unit
no
21 12 03
dd mm yy
12 00 00
hh mm ss
no
no
Fig. 29 Input mode for the system parameters:
more RS parameters
Pressing the "Enter" key will trigger an immediate
memory printout, followed by the return to Fig. 25
Result protocol: please refer to description of
function key F6 on page 51
Documentation yes / no means that a printout is to
be made after the end of a measurement series.
This requires that a printer is connected;
subsequently, press the "Enter" key to proceed to
Fig. 25
Fig. 30 Input mode for the system parameters:
date and time
At this point you can set the internal clock.
Confirm, then press the "Enter" key to proceed to
Fig. 31
Fig. 31 Input mode for the system parameters:
confirmation
This prompt is issued for data integrity reasons to
avoid the automatic take-over of any erroneous
input or changes.
Yes means: accept and store data
No means: discard changes
Press "Enter" to return to Fig. 25
Fig. 32 Input mode for the system parameters:
delete confirmation
If you confirm this question with "yes", all system
parameters will be reset to the starting valued
(default values), followed by a move to Fig. 33; if
you confirm with "no", you will be taken to Fig. 4
Fig 33 System message: method deleted
If confirmed with the "Enter" key, you will be taken
back to Fig. 4
Fig 34 System message: following a stop!
You are asked whether the capillary have run
empty in order to ensure that no malfunction will be
caused by bubbles or splashes in the case of a
restart.