SCHOTT Instruments AVS 470 Mode D'emploi page 62

57
ViscoPump parameter
pressure
ON
ramp:
pump power:
meas. delay:
time above N1:
ViscoPump parameter
save parameters?
yes
system parameter
language:
rs parameter:
documentation:
date/time:
back:
system parameter
language:
system parameter
rs parameter:
rs parameter:
Bit Stopp
7
8
7
8
7
8
Chapter 5 Working with the AVS 470 Viscosity Measuring Unit
suction
OFF
30 %
100 %
1.0 f
1.0 f
no
deutsch
english
francais
espanol
italiano
2400 Baud
4800 Baud
9600 Baud
Parity
2 No
1 No
1 Odd
1 Odd
1 Even
1 Even
Fig. 23 Input mode for the ViscoPump
parameters from Fig. 4
Pressure/Suction action: Adjustable working mode
Ramp: This refers to the steepness of the pressure
increase in terms of scale sections (1-50, default
value = 15)
Pump power: % of the programmed normal value
Measurement delay: Between the individual
measurements x factor
Above N1 Suction: Time of suction above the upper
light barrier x factor
Pressing "Enter" will take you to Fig. 24.
Fig. 24 Input mode for the ViscoPump
parameter prompt following Fig. 23
This prompt is issued for data integrity reasons to
avoid the automatic take-over of any erroneous
input or changes.
Yes means: accept and store data
No means: discard changes
Press "Enter" to return to Fig. 4.
Fig. 25 Input mode for the system parameters
from Fig. 4
Selection of the language: Proceed to Fig. 26
Selection of the RS parameters: Proceed to Fig. 27
Selection of the documentation: Proceed to Fig. 29
Set time and date: Proceed to Fig. 30
Possibility of returning to Fig. 4
Confirm, press the "Enter" key to jump to the
function
Fig. 26 Input mode for the system parameters:
Language
Select from:
German, English, French, Spanish, and Italian
Press the "Enter" key to return to Fig. 25
Fig. 27 Input mode for the system parameters:
RS baud rate
Select the baud rate 2400, 4800, or 9600
Used to adapt to the RS printer
Press the "Enter" key to proceed to Fig. 28
Fig. 28 Input mode for the system parameters:
more RS parameters
At this point you can select the word length, the
stop bit, and the parity
Used to adapt to the RS printer Press the "Enter"
key to return to Fig. 25