Sanitas SBM 37 Mode D'emploi page 28

Press the M1 button if you have selected user memory 1.
Press the M2 memory button if you have selected user
memory 2.
A flashes on the display.
The average value of all saved measured va-
lues in this user memory is displayed.
• Press the relevant memory button (M1 or M2).
AM flashes on the display.
The average value of the morning measure-
ments for the last 7 days is displayed (morning:
5.00 a.m. – 9.00 a.m.).
• Press the relevant memory button (M1 or M2).
PM flashes on the display.
The average value of the evening measure-
ments for the last 7 days is displayed (evening:
6.00 p.m. – 8.00 p.m.).
• When the relevant memory button (M1 or
M2) is pressed again, the last individual
measurement is displayed (in this example,
measurement 03).
• When the relevant memory button (M1 or M2) is pressed
again, you can view your individual measurements.
• To switch the device off again, press the START/STOP
button .
You can exit the menu at any time by pressing the
START/STOP button
• To clear the memory of the relevant user memory, you
must first select a user memory.
• Start the retrieval of the average measured values. A
flashes on the display and the average value of all saved
measured values in this user memory is displayed.
• Press and hold the memory button M1 or M2 for 5 sec-
onds depending on the user memory you are in.
All the values in the current user memory are
deleted.
28
.