Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL BT-PO 110 Instructions De Service

Anleitung BT-PO 110 SPK1:_
GB
Wash your car with a clean sponge, working from
top to bottom.
Remove all insects, bird droppings and tar stains
from the paintwork daily.
If you use any window-cleaning agents, spray
them onto a cloth and not directly onto the
windows in order to prevent them wetting the
paintwork.
6. Instructions for use
When using wax and polishes, please observe
the manufacturersʼ instructions.
Figure 2:
Pull the textile polishing cap over the polishing pad.
Make sure the polishing cap is completely clean.
Figure 3:
Spread the polishing paste evenly over the polishing
pad. Do not apply the polish directly to the polishing
surface.
Figure 4:
Switch the polishing machine on and off only when
the polishing machine is resting on the polishing
surface.
Figure 5:
Place the extension lead over your shoulder and
work first on the large, flat surfaces such as the
bonnet, boot lid and roof, keeping your movements
as regular as possible.
Important! Allow the polishing machine to glide
over the polishing surface. Do not exert
pressure!
Figure 6:
Work next on the smaller surfaces (doors, for
example). Allow the mains cable to hang from the
appliance and hold the polishing machine as
illustrated.
Figure 7:
For less accessible areas (such as wing-mirrors,
bumpers and door handles etc.), remove the
polishing cap from the pad and polish these areas by
hand.
Figure 8:
Now replace the textile polishing cap with the fine
polishing cap and pull this over the polishing pad.
Make sure it is completely clean. Remove the layer
of polish in the same order as it was applied.
8
26.11.2007 7:48 Uhr Seite 8
Important! Do not exert pressure on the polishing
machine!
7. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Wash the polishing cap only by hand and hang up
to dry.
When not in use, remove the polishing cap and
store the polishing machine upside down so that
the polishing pad can dry and retains its original
shape.
The excessive use of wax and paste can cause
the polishing cap to jump off the polishing pad
while polishing.
Use only a mild soap and damp cloth to clean the
polishing cap.
Important! Do not use any abrasive polishing
agents!
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info