Beurer BM 51 easyClip Mode D'emploi page 30

Saving, displaying and deleting measured values
The results of every successful measurement are stored
together with the date and time. If there are more than
100 measurements, the oldest measurements are lost.
• Press the SET setting button. Select the relevant user
memory ( or ) by pressing the
2
Confirm your selection using the START/STOP button
.
Press the M memory button.
lights up on the display.
The average value of all saved measured
values in this user memory is displayed.
Press the M memory button.
lights up on the display.
The average value of the morning
measurements for the last 7 days is
displayed (morning: 5 a.m. – 9 a.m.).
Press the M memory button.
lights up on the display.
The average value of the evening
measurements for the last 7 days is
displayed (evening: 6 p.m. – 8 p.m.).
- +
/ function buttons.
30
When the M memory button is pressed
again, the last individual measured
values in each case are displayed
with the date and time (for example
measurement 03).
When the memory button M is pressed again, you can
view your individual measured values.
To switch the device off again, press the START/STOP
button . If you forget to switch off the unit, it will switch
off automatically after 1 minute.
You can exit the menu at any time by pressing the
START/STOP button
To delete the memory of the selected user memory,
press the M memory button in switched-off state.
The average value of all measurements appears on
the display; in parallel, lights up.
Press and hold down both function buttons
simultaneously for 5 seconds.
appears on the display. All the
values in the selected user memory have
now been deleted.
.
-/+