Assembly; Delivery Content; Transport; Workplace Requirements - HOLZMANN MASCHINEN KAP 305JL Mode D'emploi

13

ASSEMBLY

13.1

Delivery content

Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please
understand that later claims cannot be accepted anymore.
13.2 Assembly
 Place the workpiece hold-down device (10) in the holder provided (see Figure A).
 The workpiece boom (7) mount by mounting the compensation angle (8) between the two
outrigger booms. Finally, you put the design into the holes which are positioned laterally
on the base plate.
 Insert the suction on the corresponding port on the back of the saw unit. Using the
clamping lever to put the dust bag on the suction.
13.3

Transport

When bringing the machine to the workplace you have to prepare it for transport.
These instructions have to be followed prior to every transport of the sliding compound saw
 Disconnect the machine from the power supply.
 Swing the saw arm into the lowest position and lock it in that position with the interlock
knob (23).
 Fix the saw arm with the sliding device fixing knob (22).
 Lift the machine only at the transport handle (13).
13.4

Workplace requirements

The KAP 305JL sliding compound saw has to be attached to the underground. For this purpose
there are 4 borings at the ground plate, two at the front side, two at the back side.
Furthermore you can attach the machine to compound saw stands.
Operating a non attached saw poses a security risk!
HOLZMANN Maschinen GmbH www.holzmann-maschinen.at
KAP 305JL
All manuals and user guides at all-guides.com
ASSEMBLY
40