Assembly; Hand Wheel (Fig.5); Riving Knife (Fig.6/7/8); Saw Blade (Fig.9) - HOLZMANN MASCHINEN TK 255 Manuel D'utilisation

ASSEMBLY

14 ASSEMBLY
Please check the product contents immediately after receipt for any eventual transport damage
or missing parts. Claims from transport damage or missing parts must be placed immediately
after initial machine receipt and unpacking before putting the machine into operation. Please
understand that later claims cannot be accepted anymore.
14.1

Hand wheel (Fig.5)

 Place the washer (e) on the bolt (a).
 Then place the bolt on the handle (b) and the washer (c) on the bolt.
 Fix the whole assembly to the hand wheel (17) and secure it with the hex-nut (d).
14.2

Riving knife (Fig.6/7/8)

 Set the saw blade (5) to the max. cutting depth, put it in the 0° position and lock it.
 Remove the table insert (8)
For transport reasons, the riving knife was fixed in the lower position before initial
commissioning. Only work with the machine if the riving knife (6) is in the upper
position. Fitting the riving knife (6) in the upper position is as follows:
 Loosen the locking handle (23) and push the riving knife (6) in the upper position.
 The gap between the saw blade (7) and the riving knife (6) should be 3 - 5 mm.
 Retighten the mounting screw and fix the table insert.
14.3

Saw blade (Fig.9)

 Place the saw blade guard (3) including the bolt (4) on the riving knife (6) from above so
that the bolt is tight in the slot of the riving knife (6).
 Do not tighten the bolt (4) too much; the saw blade guard (3) must be able to move
freely.
 Place the extraction hose (5a*) on the extraction adapter on the rear of the machine and
on the extraction nozzle of the saw blade guard (3).
Before starting to saw, lower the saw blade guard (3) on to the work piece!
14.4

Stand TK 255MS (optional)

The machine can be mounted on the optional accessories TK 255MS.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 30
TK 255