Cleaning And Care - Hkoenig MLK8 Manuel D'utilisation

CLEANING AND CARE

Remove the plug from power supply. Remove the jug
from the power base before cleaning.Toseparate
thelidand the siliconring from the jug.Never immerse
the jug or the base into water. Do not use the
dishwasher.
1. THE JUG: Clean immediately after each use. Flush
and clean the walls using warm soapy water and a
non-abrasive cloth. Then dry with a soft cloth. Do not
use the dishwasher.
2. THE LID: To separate the lid and the silicon ring from
the jug. Washing out with water directly.
3. THE BODY: Clean with a soft cloth.Never use sharp
cleaning agents, hard nylon brush or metal brush to
avoid scratches on the stain less steel surface!
Never clean with metal objects and never use
abrasives.
4. THE WHISKS: Remove from the jug. Wash with warm
water. Dry and store in a safe place.
5. Take out the power plug before cleaning.
6. Take out the spiral whisk or paddle, fill with water, use a
small brush to clean the gap under shaft sleeve of
motor.
7. Fix the spiral whisk, pour water into jug, water can't
exceed the max of stir, setting cold frother as the state
of milk frother , finished one time in one loop.
8. Use sponge or nonmetal soft brush to clean the inside
and outside of the jug, then wipe dry with a soft cloth.
9. When cleaning the jug, never immerse the jug fully in
water. There are electronic components in the body of
the jug that will be damaged.
10. Can't be cleaned in the dishwasher.