Cleaning And Caring For The Inverter; Troubleshooting - Dometic MSI912 Instructions De Montage Et De Service

Cleaning and caring for the inverter

11 Cleaning and caring for the inverter
A
NOTICE!
Do not use sharp or hard objects or cleaning agents for cleaning as these
may damage the product.
➤ Occasionally clean the product with a damp cloth.
12

Troubleshooting

!
WARNING!
Do not open the device. You risk sustaining an electric shock by doing
this.
I
NOTE
If you have detailed questions on the specifications of the inverter
please contact the manufacturer (addresses on the back of the instruc-
tion manual).
The 'Load Status' LED (fig. 6 3, page 4 to fig. 8 3, page 5) red indicates a fault:
LED display
Quick flashing
Slow flashing
Occasional flash-
ing
30
Cause
Input voltage is too high
Input voltage too low
Overheating
Remedy
Check the input voltage and reduce it.
The battery needs recharging.
Check the cables and connections.
Switch off the inverter and the load.
Wait about 5 – 10 minutes.
The inverter is being reset.
Then switch the inverter back on without
the load.
Reduce the load and make sure the
inverter has better ventilation. Then switch
the load back on.
SinePower
EN