Zippie Salsa M2 Mini Manuel D'utilisation page 24

5.8.3. Standard and Recline Armrest Coarse
Adjustment.
To achieve more than 25 mm Height Adjustment:
1. Use a 6.0 mm Allen key, (hexagon wrench), to loosen
the rotation bolts on both armrests (B), (Fig.5.16).
2. Remove both armrest assemblies, (Fig.5.17).
3. Remove both sets of 4mm armrest adjustment ring
bolts, (Fig.5.18).
4. Rotate both the armrest height adjustment rings,
(Fig.5.19), to match the desired height designated in
the Configuration Chart, (Fig.5.22), on next page.
5. Replace both sets of armrest adjustment ring
bolts according to the configuration chart overleaf.
(Fig.5.20)
6. Use 10 Nm or 88.5in/lb of torque.
7. Refit both armrest assemblies. (Fig.5.21)
8. Refit the armrest pivot bolts on both sides of the seat,
but do not tighten completely, (Fig.5.16).
9. Follow steps, 2 to 8 in the previous section 5.8.2.
WARNING!
Check all bolts periodically for tightness. If loose the
armpad could slip down when pressed.
Fig. 5.16
24
ZIPPIE SALSA M Mini
2
Fig. 5.17
Fig. 5.18
Fig. 5.19
Fig. 5.20
B
Fig. 5.21
Rev.C