Foot Plates - Zippie Salsa M2 Mini Manuel D'utilisation

Masquer les pouces Voir aussi pour Salsa M2 Mini:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.9.3 Foot plates

The foot plates may be flipped up to aid entry and exit
from the wheelchair.
WARNING!
Do not use the foot plates to stand on as the full weight of
your body may cause the wheelchair to tip forwards. This
could result in injury and could damage the foot rests.
Adjusting the foot rest length:
5.9.4 Swing-away leg rest:
To adjust the foot rest length:
Remove the bolts/screws on the foot rest stem as
shown in (Fig. 5.33),
Adjust the length to suit.
Ensure the bolts/screws are firmly located and
tighten ed prior to use.
NOTE: The internal foot rest stem may require cutting
down in length to allow the foot plate position to be
raised. Contact your approved Sunrise Medical dealer.
Fig.5.33
5.9.5 Manual Centre Mount Leg rest
To adjust the foot rest length:
Remove the bolt on the foot rest plate as shown in
(A-Fig. 5.34),
Adjust the length to suit.
Refit bolt.
Ensure the bolts/screws are firmly located and
tighten ed prior to use.
Rev.C
Fig.5.34
A
5.9.6 Manual Articulating / Elevating Leg rest
To elevate:
Pull the leg rest upwards and stop at the desired height.
The leg rest will automatically lock in the chosen
position.
To lower:
Push the release lever slowly forward. The leg rest will
lower the angle. As soon as you release the lever, the
leg rest will be locked in the current position, (Fig.5.35).
WARNING!
Keep hands clear of the adjustment mechanism
between the frame and the movable parts of the leg rest
while elevating or lowering the leg rest.
Keep hands clear of the adjustment mechanism
between the frame and the movable parts of the leg rest
while elevating or lowering the leg rest.
Fig.5.35
LEVER
29
ZIPPIE SALSA M
Mini
2

Publicité

Table des Matières
loading

Table des Matières