Operation - Ryobi P521 Manuel D'utilisation

WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Cutting wood surfaces
 Cutting thin sheet metal
 Cutting plastics and laminates
This product will accept Ryobi One+ 18 V lithium-ion battery
packs and Ryobi One+ 18 V nickel-cadmium battery packs.
For complete charging instructions, refer to the Operator's
Manual for the battery packs and chargers for your models.
BATTERY PROTECTION FEATURES
Ryobi lithium-ion batteries are designed with features that
protect the lithium-ion cells and maximize battery life.
If the tool stops during use, release the trigger to reset and
resume operation. If the tool still does not work, the battery
needs to be recharged.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
ASSEMBLY
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.

OPERATION

TO INSTALL/REMOVE BATTERY PACK
See Figure 2, page 12.
To install:
 Lock the switch trigger by releasing it all the way.
 Place the battery pack on the tool.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured on the
tool before beginning operation.
To remove:
 Lock the switch trigger by releasing it all the way.
 Depress the latches on the side of battery pack.
 Remove the battery pack from the tool.
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be locked when not
in use or carrying at your side.
BLADE STORAGE
See Figure 3, page 12.
The blade storage compartment is located on the back of
the saw. It is convenient for storing extra blades and storing
blades when not in use.
 To open: Push the door down with your thumb or finger.
Place blades in blade storage compartment.
 To close: Push the door up with your thumb or finger.
LASER GUIDE
See Figure 4, page 13.
Depress the laser guide switch to generate a red laser beam
on the work surface in front of the saw. Use the laser to guide
the saw along the line of cut.
8 - English