3-Position (Gf3) Model - VALPES DV 25 Manuel D'installation Et D'utilisation

3 positions (GF3) : description
Actuator with a third position
GF3 option allow actuator to be drive and stop in 3 positions. These 3 positions could be between 0° to 180°.In standard actu-
ators are setting in our workshop at 0° 90° 180° that's fit with standard 3 ways ball valve. Others positions still available but
customer have to price on the order witch position is request.
Electric connection
Power supply and control wiring

Ensure that the voltage indicated on the actuator ID label corresponds to the voltage supply.

Unscrew the left cable gland and insert the cable.

Remove 25mm of the cable sheath and strip each wire by 8mm.

Connect the wires to the terminal strip in accordance with the diagram p. 39.

Tighten the cable gland (Ensure that it's well mounted to guaranty the proofness).
The actuator is pre-set in our factory. Do not touch the four lower cams in order to avoid any malfunctioning or
even damage to the actuator.
Feedback wiring and contacts state

Unscrew the right cable gland and insert the cable.

Remove 25mm of the cable sheath and strip each wire by 8mm.

Connect the wires to the terminal strip in accordance with the diagram p. 39.

Tighten the cable gland (Ensure that it's well mounted to guaranty the proofness).
Our 3-position actuators have 3 auxiliary switches
FC1 (white cam - 5th): open position feedback - NO
FC2 (black cam - 6th) : closed position feedback - NO
FC3 (beige cam - 7th) : intermediate position feedback - NC
To adjust the position of the auxiliary contacts, make rotate the 3 superior cams by using the appropriate wrench.
38
Terminals
6 & 9 4 & 8
0° Closed Open
inter Open Open
180° Open Closed
DSBA3800 • Rév. 01/10/2020
EN
F4 & F9
Closed
Open
Fermé