Hendi 272602 Mode D'emploi page 8

To light the patio heater
• The pilot should be lit and the knob set to PILOT.
• Press the knob 3mm and turn anti-clockwise to
HIGH.
• When mesh glows lit, turn knob clockwise from
HIGH to LOW as needed.
Re-lighting
Note: For your safety, Control Knob cannot be turned OFF without first depressing Control Knob in PILOT
position and then rotating it to OFF.
• Turn Control Knob to OFF.
• Wait at least 5 minutes, to let gas dissipate, be-
fore attempting to re-light pilot.
To extinguish
• Hold knob depressed & turn the knob clockwise
to 'OFF'
• Close the valve of the gas cylinder or the regula-
tor after use.
Leak testing
NEVER USE A NAKED FLAME TO CHECK FOR LEAKS.
NEVER LEAK TEST WHILE SMOKING
EN
The gas connections on this appliance are leak
tested at the factory prior to shipment.
This appliance needs to be periodically checked
for leaks and an immediate check is required if the
smell of gas is detected.
• Make a soap solution using 1 part of liquid
dish-washing soap to 3 parts water. The soap
solution can be applied with a soap bottle, brush,
or rag to the leak tested points shown in the fig-
ure above.
• The valve of the gas cylinder should be in the OFF
position at this point of the leak test. Once the
soapy solution is applied to the gas connections,
the valve of the gas cylinder needs to be turned to
the ON position.
Gas requirements
• The pressure regulator and hose assembly to be
used must conform to local standard codes.
• Never use a gas cylinder with a damaged body,
valve, collar, or foot ring.
• A dented or rusty gas tank may be hazardous and
should be checked out by a gas supplier.
• Never connect this appliance to an unregulated
gas source.
8
Note: The burner may be noisy when initially
turned on. To eliminate excessive noise from the
burner, turn the control knob to the pilot position.
Then, turn the knob to the level of heat desired.
• Repeat the "Lighting" steps
• Allow this appliance to cool before moving.
Note: After use, some discoloration of the emitter
screen is normal.
• Soap bubbles will begin to form in the soapy solu-
tion if a leak is present.
• In case of a leak, turn off the gas supply. Tighten
any leaking fittings, then turn the gas supply on
and recheck.
Leak Test Point 1 2
• When the appliance is not in use, turn the gas
cylinder OFF.
• Always perform a leak test on gas connections
whenever a cylinder is connected. If bubbles form
in the leak test solution, do not use. Never use a
flame to test for leaks.