Hendi 272602 Mode D'emploi page 10

Note: in a salt-air environment (such as near the
sea), corrosion occurs more quickly than normal.
Servicing
• Please consult your local dealer for servicing this
appliance and replacement of its parts. The ser-
vicing of the appliance shall be carried out only by
authorised personnel.
Storage
Between uses:
Turn control knob OFF
Turn gas cylinder OFF
Store Heater upright in an area sheltered from di-
rect contact with inclement weather (such as rain,
sleet, hail, snow, dust and debris).
If desired, cover to protect exterior surfaces and to
prevent build up in air passages.
Note: Wait until heater is cool before covering.
EN
CAUTION: DO NOT USE UNAUTHORISED PARTS OR COMPONENT FOR THIS APPLIANCE.
ONLY USE ORIGINAL EQUIPMENT REPLACEMENT PARTS AND COMPONENTS.
To retract the heater (272701 only)
Retracting the heater makes storage much eas-
ier. Loose the plastic screw (17) properly. Pull up
the main post vertically until it encounters housing
lid. Turn the main post clockwise and lower it until
it has reached the desired level. To lock the main
post on the desired level pull up the main post just
10
Frequently check the corroded areas and repair
them promptly.
• Caution: do not use unauthorized parts or com-
ponents for this appliance, only use original
equipment replacement parts and components.
The use of unauthorized parts or components
will void the warranty and can create an unsafe
condition.
During periods of extended inactivity or when
transporting:
Turn control knob OFF.
Disconnect gas cylinder and move to a secure, well
ventilated location outdoors. DO NOT store in a lo-
cation that will exceed 50°C.
Store heater upright in an area sheltered from di-
rect contact with inclement weather (such as rain,
sleet, hail, snow, dust and debris).
If desired, cover heater to protect exterior surfaces
and to prevent build up in air passages.
Note: Wait until heater is cool before covering
a little and turn it counter clockwise. Then lower it
until the main post stands on its screws. Tighten
the plastic screw to keep the heater stable.
Note: Mind your head. Wait until heater is cool be-
fore retracting.