Hendi 272602 Mode D'emploi page 7

Optional base stand
Base stand assembly parts: 6pcs bolts M5 x 10 and
6pcs washers for base stands and base.
Attach 3pcs stands to the base.
Buy suitable hook bolts or rawlbolts from your lo-
Optional wheels
Wheels assembly parts: 2pcs bolts, 4pcs washers
and 2pcs nuts for wheels assembly.
Collect wheels parts together and fix wheels to the
base. (See Figure 4)
Operating instructions
Before first use and after every gas cylinder change, gas delivery system must be purged of air before ig-
niting! To do this, turn the control knob counter-clockwise to the pilot setting. Press knob in and hold for 3
minutes before attempting ignition.
To light the pilot
• Check all connections prior to each use.
• Turn on main gas supply.
• Press to turn control knob counter-clockwise to
PILOT, see right photo.
• Hold knob depressed, press IGNITION button re-
peatedly until pilot flame is lit, then continue to
hold the knob depressed for 10 seconds until the
pilot remains it after releasing knob.
• If pilot fails to ignite or alight, press to turn knob
clockwise to OFF and repeat.
cal market to insert them into the ground or floor
through base stand holes for this appliance stabil-
ity. (See Figure 3)
Fig. 3
Fig. 4
EN
7