Hendi 272602 Mode D'emploi page 6

Patio heater assembly
Assembly instructions
• Screwdriver / Adjustable Spanners / Wrenches
• Leak Detection Solution one part detergent and
three parts water
• Before assembly, make sure all protection pack-
ing material must be moved.
• Assembling all nuts and bolts loosely at first.
Tighten all connections after completion of as-
sembly. This eases your work and increase the
stability of your appliance.
• Small deviations in equipment may occur. This is
no lack of quality but subject to improvements.
SETP 1: Screw rear panel of housing to the base
with 5pcs bolts M5 x 12 and 5pcs washer.
(Detail Abb. A)
SETP 2: Push the housing lid over rear panel of
housing and place onto rear panel of
housing. Screw together the housing lid
and rear panel of housing with 5pcs bolts
M5x12 and 5pcs washers. (Detail Abb. B)
EN
SETP 3: Fix the post assembly upwards onto the
housing lid with 4pcs bolts M6 x 12 and
4pcs washers, then put plastic cover
through the post. (Detail Abb. D-2)Connect
the post assembly with 3pcs M5x12 screw
and 3pcs flat washer. (Detail Abb. D-1)
SETP 4: Fix one piece reflector to the central dome
with 1pc bolt M6*8, 1pcs cap screw, 1pcs
flat washer firstly. (Detail Abb. E-1).Con-
nect the second reflector part to the first
one and central dome with 3pc bolt M6x8,
3pcs cap screw, 3pcs flat washer later.
(Detail Abb. E-2). Fix the third reflector
part with 5pc bolt M6x8, 5pcs cap screw,
5pcs flat washer at last. (Detail Abb. E-3)
SETP 5: Tighten inner gas pipe to main burner (See
Figure 1), Then fix main burner to the post
with 3 bolts M5x12 and 3pcs washers. (De-
tail Abb. F)
NOTE: DO NOT OVER TIGHTEN! REFER TO
LEAK TESTING ON PAGE 5.
6
SETP 6: Fix the door to housing. (See Figure 2 and
Detail Abb. F)
D-1
13
12
D-2
13+20
14+15+21
5
17
13 12