Maintenance; Troubleshooting; Storage And Disposal - Husqvarna epos reference station Manuel D'utilisation

4.1 Introduction - maintenance
Do a check of the installation each year.
Screw
Upper to lower chassis
Reference station to arm
Arm to post
Arm, support bracket and post bracket
4.2 Clean the product
WARNING:
from the power supply before any
maintenance or cleaning.
5.1 LED indicator lamp on the reference station
Light
Green flashing light
Green constant light
Red flashing light
White flashing light
6.1 Storage
If you store the reference station indoors, keep the arm
installed at the post or wall to be able to install the
reference station on its original position again.
If you keep the reference station outdoors during the
winter, we recommend you to keep the power supply
connected.
1512 - 002 - 08.11.2021

4 Maintenance

Tool
Torx 20
Torx 20
Hex key, 4 mm
Hex key, 4 mm
Disconnect the product

5 Troubleshooting

Status
Startup of the reference station. This can take some minutes.
In operation.
The reference station is not working due to an error. Restart the product. If the prob-
lem stays, speak to your approved servicing dealer.
Firmware update is necessary. Speak to your local Husqvarna representative.

6 Storage and disposal

1. Make sure that the post is tightly attached.
2. Do a check of the tightening torques for all screws.
Tightening torque (Nm)
1.8
1.8
5-6
5-6
CAUTION:
Do not use a high-pressure
washer to clean the product. Do not use
solvents for cleaning.
If necessary, clean the product with a moist cloth.
6.2 Disposal
Obey the local recycling requirements and applicable
regulations.
Maintenance - 9