Safety; Safety Definitions; Safety Instructions For Installation; General Safety Instructions - Husqvarna epos reference station Manuel D'utilisation

2.1 Safety definitions

Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING:
injury or death for the operator or bystanders
if the instructions in the manual are not
obeyed.
CAUTION:
Used if there is a risk of
damage to the product, other materials or
the adjacent area if the instructions in the
manual are not obeyed.
Note:
Used to give more information that is necessary
in a given situation.

2.2 General safety instructions

WARNING:
instructions that follow before you use the
product.
• Obey national regulations about electrical safety.
• The product is only to be used with the power
supply unit supplied by Husqvarna.
• The product may only be used with the equipment
recommended by the manufacturer. All other types
of use are incorrect. The manufacturer's
instructions with regard to operation/maintenance
must be followed precisely.
• The product may only be operated, maintained and
repaired by persons that are fully conversant with
its special characteristics and safety regulations.
Please read the Operator's Manual carefully and
make sure you understand the instructions before
using the product.
• Husqvarna does not guarantee full compatibility
between the product and other types of wireless
systems such as remote controls, radio
transmitters, hearing loops, underground electric
animal fencing or similar.
• It is not permitted to modify the original design of
the product. All modifications are made at your
own risk.
• The operating temperature is -20°C to 45°C / -4°F
to 113°F. The storage temperature is -20°C to
70°C / -4°F to 158°F.

4 - Safety

2 Safety
Used if there is a risk of
Read the warning

2.3 Safety instructions for installation

WARNING:
instructions that follow before you use the
product.
• Do not put the power supply at a position where
there is a risk that it can become wet. Do not put
the power supply on the ground.
• Do not encapsulate the power supply. Condensed
water can harm the power supply and increase the
risk of electrical shock.
• Risk of Electric Shock. Install only to an residual-
current device (RCD) when connecting the power
supply to the wall socket. Applicable to USA/
Canada. If power supply is installed outdoors: Risk
of Electric Shock. Install only to a covered Class A
GFCI receptacle (RCD) that has an enclosure that
is weatherproof with the attachment plug cap
inserted or removed.
• Make sure that the plugs of the low-voltage cable
and the power supply unit are clean and dry before
you connect them.
• There is a risk of falling objects during the
installation of the reference station. This can result
in injury.
• The power supply cable and extension cable must
be outside the work area to avoid damage to the
cables.
• There is a risk of falling when you install the
reference station in a high position. Make sure that
you have a stable position when you install the
reference station.

2.4 Safety instructions for maintenance

WARNING:
instructions that follow before you use the
product.
• Disconnect the product from the power supply
before you clean or do maintenance on the
product.
2.5 In the event of a thunderstorm
To decrease the risk of damage to electrical
components in the reference station, we recommend
that the power supply to the reference station is
disconnected if there is a risk of a thunderstorm.
Connect the power supply again when there is no a risk
of thunderstorm.
Read the warning
Read the warning
1512 - 002 - 08.11.2021