Installation; Introduction - Installation - Husqvarna epos reference station Manuel D'utilisation

3.1 Introduction - Installation

WARNING:
safety chapter before you install the product.
CAUTION:
Use original spare parts and
installation material.
Note:
Refer to www.husqvarna.com for more
information about installation.
3.2 To examine where to put the
reference station
CAUTION:
If there is a lightning rod
near by, do not install the reference station
higher than the lightning rod.
CAUTION:
Do not install the reference
station on a flagpole. Movements of the
reference station will affect the correction
data sent to the product with the accurate
position.
• Install the reference station on a fixed object that
cannot move or rotate.
• Install the reference station on a post or a wall.
The post must be 32-55 mm / 1.26-2.16 in. in
diameter to fit the attachments on the reference
station.
Note:
If the reference station is installed on a
wall the top of the reference station must be above
the wall. There must be no metal in the wall.
• The reference station needs to have full view of the
sky. The sky must be visible without obscuration in
all directions above 10° elevation angle.
1512 - 002 - 08.11.2021

3 Installation

Read and understand the
160°
10°
• Install the reference station at minimum 2.5 m / 8
ft. height.
• The maximum distance between the reference
station and the product is 500 m / 1640 ft. when
free line of view. Objects between the reference
station and product decreases the distance.
• Install the reference station where the radio signal
reaches all parts of the work area. Large objects
can block the radio signals.
• It is recommended to have free line of sight
between product and reference station for optimal
performance.
• Special settings are necessary if the site has more
than one robotic lawn mower and reference
station. Speak to your local Husqvarna
representative for more information.
3.3 To examine where to put the power
supply
WARNING:
cable. There is a risk of electrical shock.
CAUTION:
Make sure that the blades
on the robotic lawn mower do not cut the
power cables.
• Put the power supply in an area with a roof and
protection from the sun and rain.
• Put the power supply in an area with good airflow.
• Use a residual-current device (RCD) when you
connect the power supply to the power outlet.
• Extend the low-voltage cable if necessary. The
low-voltage cable can be extended up to 100 m /
328 ft.
10°
Do not cut the low-voltage
Installation - 5