Safety Instructions; Electrical Connection - AEG RMB76311NX Mode D'emploi

24 www.electrolux.com
• Do not use water spray and steam to clean the
appliance.
• Clean the appliance with a moist soft cloth. Only use
neutral detergents. Do not use abrasive products,
abrasive cleaning pads, solvents or metal objects.
• Do not store explosive substances such as aerosol
cans with a flammable propellant in this appliance.
• If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
• If the appliance is equipped with an Ice maker or a
water dispenser, fill them with potable water only.
• If the appliance requires a water connection, connect
it to potable water supply only.
• The inlet water pressure (minimum and maximum)
must be between 1 bar (0,1 MPa) and 10 bar (1 MPa)
2.

SAFETY INSTRUCTIONS

2.1 Installation
• Do not install or use a damaged
appliance.
• Obey the installation instruction
supplied with the appliance.
• Always be careful when you move the
appliance because it is heavy. Always
wear safety gloves.
• Make sure the air can circulate around
the appliance.
• Wait at least 4 hours before connecting
the appliance to the power supply. This
is to allow the oil to flow back in the
compressor.
• Do not install the appliance close to
radiators or cookers, oven or hobs.
• The rear of the appliance must stand
against the wall.
• Do not install the appliance where
there is direct sunlight.
• Do not install this appliance in areas
that are too humid or too colds,
such as the construction appendices,
garages or wine cellars.
150213_UM of FrenchDoor-AEG_NL-EN-FR-DE-LT-PL-PT-ES.indd 24
WARNING!
Only a qualified person must
install this appliance. Remove all
the packaging.
• When you move the appliance, lift it by
the front edge to avoid scratching the
floor.

2.2 Electrical connection

WARNING!
Risk of fire and electrical shock.
The appliance must be earthed.
• M a k e s u r e t h a t t h e e l e c t r i c a l
information on the rating plate agrees
with the power supply. If not, contact
an electrician.
• A l w a y s u s e a c o r re c t l y i n s t a l l e d
shockproof socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to the
electrical components (e.g. mains plug,
mains cable, compressor).
• Contact the Service or an electrician to
change the electrical components.
• The mains cable must stay below the
level of the mains plug.
2016-09-20 10:24:28