Setting The Date; Using The Chronograph - Timex W236 Mode D'emploi

ENGLISH

SETTING THE DATE

1) PULL the crown out to the 1st position "B".
2) Turn the crown counter-clockwise to set the date.
*If the date is set between the hours of around
9:00 PM and 1:00 AM, the date may not change
on the following day.
3) After the date has been set, push the crown back
to the normal position "A".

USING THE CHRONOGRAPH

This chronograph is able to measure and display time
in 1/1 second united up to maximum of 11 hours
59 minutes 59 seconds. The chronograph second
hand keeps continuously for 11 hours 59 minutes
59 seconds after starting.
MEASURING TIME WITH THE
CHRONOGRAPH
1) The chronograph can be started and stopped
each time pusher "A" is pressed.
2) Pressing pusher "B" resets the chronograph and
the chronograph second hand, chronograph
18
ENGLISH
minute hand, and chronograph hour hand return
to zero position.
TIME MEASUREMENT
RESET
CHRONOGRAPH RESET (INCL. AFTER
REPLACING BATTERY)
This procedure should be performed when the
chronograph second hand does not return to zero
position after the chronograph has been reset, and
including after the battery has been replaced.
1) Pull the crown out to the 2nd position "C".
2) Press pusher "A" to set the chronograph second
hand to the zero position. The chronograph hand
can be advanced rapidly by continuously pressing
pusher "A".
3) Once the hand returns to zero position, return the
crown to the normal position.
19
STOP