Timex W236 Mode D'emploi page 11

ENGLISH
BEFORE USING THE CHRONOGRAPH, adjust all
the chronograph hands to the "0" or 12-hour
positions.
TO ADJUST CHRONOGRAPH HANDS:
1. PULL crown out to "B" position.
2. PRESS pusher "B" until the hand at the 10 o'clock
eye resets to the "30" position.
3. PULL crown out to "C" position.
4. PRESS pusher "A" until the chronograph second
hand resets to the "0" or "60" or 12-hour posi-
tion.
5. PRESS pusher "B" until the hand at the 2 o'clock
eye resets to the "0" position.
6. PUSH in Crown to "A" position.
NOTE:
• Make sure the chronograph is stopped and reset
before adjusting.
• PRESSING and HOLDING either pusher "A" or "B"
for 2 seconds will cause the hands to move
continuously until the pusher is released.
14
ENGLISH
STANDARD CHRONOGRAPH
MEASUREMENT:
1. PRESS pusher "A" to start timing.
2. PRESS pusher "A" to stop timing.
3. PRESS pusher "B" to reset.
SPLIT TIME MEASUREMENT:
1. PRESS pusher "A" to start timing.
2. PRESS pusher "B" to split.
3. PRESS pusher "B" to resume timing.
4. PRESS pusher "A" to stop timing.
5. PRESS pusher "B" to reset.
INDIGLO ® NIGHT-LIGHT
With the crown in the "A" position, PUSH crown to
the "D" position. Entire dial will be illuminated.
Electroluminescent technology used in INDIGLO
night-light illuminates entire watch face at night and
in low light conditions.
15
®