Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. Using the proper drill type, drill 4 holes aligned through the
motor housing mounting brackets (2 holes each bracket) into
the floor. Using 4 screws (not supplied) for floor type, secure
the blower motor assembly to the floor.
A. Floor
B. Wood screws M6 x 16 mm (4)
5. Install recirculation duct assembly through the cabinet
kick plate to the blower motor assembly venting outlet.
A
B
C
D
E
F
G
A. Blower motor assembly bottom duct extension
B. Mounting screws (4) – rectangular duct to blower motor
assembly bottom duct extension
C. Rectangular duct extension
D Recirculation duct assembly
E. Mounting screws (4) – recirculation duct assembly to cabinet
F. Cover – recirculation duct assembly
G. Fasteners – cover (2)
6. Install recirculation duct assembly through front rectangular
hole in kick plate (Cutout location – see "Style 2 – Cabinet
Cutouts for Recirculation Front Kick Plate Installations" in
the "Cutout Dimensions" section.)
NOTE: Ensure the 2 charcoal filters are installed inside
the recirculation duct assembly housing.
7. Use metal duct tape to secure and seal all duct joints.
B
A
Style 3 – Recirculation Cabinet Side Installations
(Use "Style 3 – Cabinet Cutouts for Side Recirculation
Installations" in the "Cutout Dimensions" section for recirculation
out of the cabinet side.)
IMPORTANT: The sub-floor under the cabinet must be the same
surface height as the cabinet bottom. An additional piece of
sub-flooring may be needed.
Floor
Floor
1. Set blower motor onto the floor through the cutout in
the cabinet floor with the vent outlet towards the right-
or left-side of the cabinet.
A
B
C
A. Blower motor assembly
B. Mounting tabs of blower motor assembly
C. Cutout in cabinet floor
D. Cabinet floor
E. Floor
2. Align the blower motor assembly 2-piece telescoping vertical
duct to the 90° elbow from the cooktop assembly. Extend
inner section of the 2-piece telescoping rectangular vertical
duct to fit over 90° elbow from cooktop assembly. Secure
with 4 M4 x 9.5 mm screws.
B
A. 90° duct to cooktop assembly
B. M4 x 9.5 mm screws (4)
C. Upper vertical duct
D. Lower vertical duct
Sub-floor
Sub- oor
under cabinet
under cabinet
Bottom of cabinet
Bottom of Cabinet
D
E
A
B
C
D
15
Publicité
Table des Matières
