Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Install Foam Strips
1. Remove foam strip from literature and hardware package.
2. Measure and cut 4 pieces: 2 pieces 21
and 2 pieces 35" (88.9 cm) long.
3. Remove backing from the 21
apply the foam strips, adhesive-side down, to each end of
the outer flange on the underside of the cooktop trim.
4. Remove backing from the 35" (88.9 cm) foam strips and
apply the foam strips, adhesive-side down, to the front and
rear outer flanges on the underside of the cooktop trim.
Do not overlap the foam strips.
B
A
A
B
A
C
A. Foam strip - 21
/
1
B. Foam strip - 35" (88.9 cm) long (2 pieces)
C. Cooktop trim - edge flange (right and left sides)
D. Cooktop trim - edge flange (front and rear)
NOTE: The foam strip (optional) keeps the underside of the
cooktop frame from debris and helps the cooktop sit flat on
uneven counters.
10
/
" (54.0 cm) long
1
4
/
" (54.0 cm) foam strips and
1
4
B
D
" (54.0 cm) long (2 pieces)
4
Cooktop Mounting Brackets Installation
NOTE: For ease of installation, install cooktop mounting
brackets to cabinet before installing cooktop into cabinet.
Installing Mounting Brackets to Cabinet Sides
NOTE: Cabinets wider than 36" (91.4 cm) may require additional
sides (Z\x" [1.3 cm] thick wood, minimum) to be constructed
inside of the cabinet at a width of 34>\zn" (87.8 cm). The inside
of each sidewall should be located 17>\cx" (43.9 cm) from the
center line of the cooktop cutout and parallel to the sides of the
cooktop cutout.
1. Draw a horizontal line on the inside of both cabinet sides or
added sidewall 1C\zn" (30 mm) down from the top surface of
the countertop.
2. Align the 4 brackets 1M\," (47 mm) from the front and back
cutout surface of the countertop on the marked horizontal
lines and orient as shown with 1 front bracket and 1 rear
A
bracket on each side.
1
/
"
7
(30 mm)
8
(47 mm)
A
B
C
A. Marked location lines on inside of
cabinet sidewalls (typical both ends)
B. Cooktop mounting brackets (4)
C. M4 x 12 mm screws (8)
3. Mark and pre-drill the mounting holes using a Z\," (3 mm)
drill bit. (Do not drill through the cabinet sidewalls.)
4. Using 2 M4 x 12 mm mounting screws (supplied) for each
mounting bracket, attach the 4 mounting brackets to the
cabinet sides. A shorter screw length (not supplied) may
be required if the cabinet sidewall thickness is less than
Z\x" (12.7 mm).
1
"
/
7
8
(47 mm)
1
/
"
3
16
A
Publicité
Table des Matières
