Instructions For Use; Setting Into Operation; Normal Deactivation And Emergency Deactivation Procedures; Editing A Program - Carlo De Giorgi Sterilintraplant Plus Manuel D'utilisation

STERILINTRAPLANT PLUS

5.2 - INSTRUCTIONS FOR USE

5.2.1 - Setting into operation

After performing the installation procedures the appliance can be set into
operation:
1) equip the micromotor with the required handpiece and tool;
2) switch on the appliance by means of the main power switch (6, Fig. 2);
3) select the program number by positioning the cursor using the "shift"
key (7, Fig. 6) in field 1 shown in figure 8, and then using the "Up ▲"
and "Down ▼" keys until obtaining the program required;
4) if there is no program saved in the memory that is suitable in relation
to the operation you are about to perform, use the edit procedure to
change one of the existing programs appropriately (see § 5.2.3);
5) push the footswitch lever to start the motor; use the previously
described control devices on the footswitch (see § 5.1) to start or stop
the water pump and reverse the direction of run of the motor as
required.

5.2.2 - Normal deactivation and emergency deactivation procedures

The appliance can be deactivated as follows:
- by releasing the footswitch;
- by setting the main power switch to OFF;
- by unplugging the power cable from the electrical socket outlet.
5.2.3 – Editing a program
To edit a program (see Figs. 6 and 8): position the cursor on the "program
n°" field and use the "Up ▲" and "Down ▼" keys to select the number of
the first free or unused program.
Once you have selected a program to edit, move around the fields using
the "shift" key and change the relative parameter values with the "Up ▲"
and "Down ▼" keys; when you have finished the edit procedure to save
the program return to the "program n°" field and then quit the program by
going to the next or the previous program by pressing "Up ▲" or "Down ▼".
If the appliance is switched off before this final step the changes to the
parameter values will not be saved in the memory and the new program
settings will be lost.
A maximum of 32 programs can be saved in the memory.
ALWAYS SWITCH OFF THE APPLIANCE WHEN YOU FINISH WORKING WITH
IT AND FOLLOWING ALL STOPPAGES, IRRESPECTIVE OF THE MOTIVE.
IF YOU NOTICE MALFUNCTIONS, STOP THE APPLIANCE IMMEDIATELY AND
DISCONNECT IT FROM THE ELECTRICAL POWER SUPPLY. BEFORE
Carlo de Giorgi GB- 11