Carlo De Giorgi Sterilintraplant Plus Manuel D'utilisation page 26

8
r1
Figure 8 shows the data that appear on the display as described below:
1) sequential program number (from 00 to 31);
2) Ncm "xxx" : describes the torque (power) available at the tool tip;
3) H2O percentage ( % ): indicates the quantity of water delivered;
4) r1 / r2: indicates which of the two micromotors is selected (r1 or r2);
5) transmission ratio between motor and speed reducer or speed
multiplier (this parameter is set in accordance with the handpiece
installed); reducers are identified by the first digit, multipliers by the
second: e.g. 32/1 indicates that speed reducer 32 has been selected,
while 1/5 corresponds to speed multiplier 5; when the reducers or
multipliers are changed the torque (2) and speed (6) values are
updated automatically on the display since these values depend on the
currently selected reducer or multiplier;
6) RPM "xxxxx" (200 ... 40000 rpm): shows the rpm (speed) delivered by
the motor if no reducers or multipliers are selected, or the spindle
speed if a reducer or multiplier has been selected.
5
GB - 10
6
5
r2
Fig. 6
1
STERILINTRAPLANT PLUS
3
2
7 1
2
Fig. 8
9
10
Fig. 7
3 4
Carlo de Giorgi
4
6