Troubleshooting; Installation; Safety; General Safety Instructions - Stiebel Eltron SHC 10 Utilisation Et Installation

OPERATION

Troubleshooting

5. Troubleshooting
Problem Cause
The appliance does not The temperature
supply hot water. selector is set
to "*".
No power at the
appliance.
Water can only be The aerator in
drawn at a reduced the tap is scaled
rate. up or dirty.
Loud boiling noises in- The appliance is
side the appliance. scaled up.
Water drips from the The safety valve
safety valve after is scaled up or
heat-up. dirty.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your enquiry, please provide the serial
number from the type plate. (000000):
O-No. 000000
F-No. 0000 - 000000
www.stiebel-eltron.com
Remedy
Switch the appliance ON by turning
the temperature selector.
Check the plug / fuses in the fuse
box.
Descale / replace the aerator.
Have the appliance descaled by a
qualified contractor.
Switch the appliance off. Depressur-
ise the appliance by disconnecting
it from the power and water supply.
Have the safety valve checked by a
qualified contractor.

INSTALLATION

6.

Safety

Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
6.1

General safety instructions

We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
6.2

Instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
7.

Appliance description

The sealed unvented (pressurised) appliance is only suitable for
undersink installation. The appliance is intended for heating cold
water and to supply one or several draw-off points.
The appliance may only be installed with pressure taps in con-
junction with a type-tested safety valve (see chapter "Installation /
Appliance description / Standard delivery").
The type-tested safety valve protects the appliance against unac-
ceptable excess pressure.
The enamelled internal steel cylinder is equipped with a protective
anode. The protective anode protects the inner cylinder against
corrosion.
7.1

Standard delivery

The following are delivered with the appliance:
- Wall mounting bracket
SHC 10 | SHC 15 Stiebel
- Two reducers from G 1/2 to G 3/8
SHC 10 GB Eltron | SHC 15 GB Eltron
- Two locking ring fittings G 1/2 x 15
7.2

Accessories

SHC 10 | SHC 15 Stiebel
- Safety assembly G 1/2 (optional)
SHC 10 | SHC 15 | 5