CONTENTS | SPECIAL INFORMATION
1.
1.1
1.2
1.3
2.
Safety ����������������������������������������������������������3
2.1
Intended use ������������������������������������������������������ 3
2.2
2.3
Test symbols ������������������������������������������������������ 4
3.
3.1
Settings ������������������������������������������������������������ 4
4.
5.
6.
Safety ����������������������������������������������������������5
6.1
6.2
7.
7.1
7.2
Accessories �������������������������������������������������������� 5
8.
Preparations ��������������������������������������������������6
8.1
9.
Installation ����������������������������������������������������6
9.1
9.2
9.3
9.4
Power supply ����������������������������������������������������� 7
10.
10.1
10.2
11.
Settings �������������������������������������������������������8
11.1
12.
Shutdown �����������������������������������������������������8
13.
13.1
14.
Maintenance ��������������������������������������������������8
14.1
14.2
14.3
14.4
14.5
14.6
14.7
14.8
14.9
2
| SHC 10 | SHC 15
15.
Specification ������������������������������������������������ 10
15.1
15.2
15.3
15.4
15.5
15.6
15.7
Data table �������������������������������������������������������� 11
GUARANTEE
ENVIRONMENT AND RECYCLING
SPECIAL INFORMATION
- The appliance may be used by children aged 8
and older and persons with reduced physical,
sensory or mental capabilities or a lack of ex-
perience and know-how, provided that they are
supervised or they have been instructed on how
to use the appliance safely and have understood
the resulting risks. Children must never play with
the appliance. Children must never clean the ap-
pliance or perform user maintenance unless they
are supervised.
- When permanently connected to the power sup-
ply using a dedicated junction box, the appliance
must be able to be isolated from the mains power
supply by an isolator that disconnects all poles
with at least 3 mm contact separation.
- The power cable may only be replaced (for exam-
ple if damaged) by a qualified contractor author-
ised by the manufacturer, using an original spare
part.
- Secure the appliance as described in chapter "In-
stallation / Installation".
- Observe the maximum permissible pressure (see
chapter "Installation / Specification / Data table").
- Drain the appliance as described in chapter "In-
stallation / Maintenance / Draining the appliance".
- The appliance is pressurised. During the heat-up
process, expansion water will drip from the safety
valve.
www.stiebel-eltron.com